2000 formula firebird project
- Thread starter trigger
- Start date
Chris Hansen
Club Member
It still is..
trigger
Club Member
Thanks man! As for the intercooler the owner of the shop rigged that up as a joke, the plan is to be ready to go forced induction within the next two seasons. As for now the engine would techinically still be considered "cam only". I have been contemplating building a good shortblock and running a bunch of nitrous this season though.
trigger
Club Member
A couple more photos of it. I need to get an adjustable PHB on the car and center the rearend side to side, but for the most part I'm happy with where we are at so far. Finish up the 8 point bar, install transmission, get a driveshaft made and I should be good. Oh, and put the engine back in the car.
Again, intercooler was a joke.
Again, intercooler was a joke.
Chris Hansen
Club Member
Bar is almost 100% tacked in. Should be done by today.
xtremewheelz
Club Member
Damn, looks like it's going to be badass when it's all finished. Good luck.
Chris Hansen
Club Member
Dont have any real good pics of the notch, I was going to wait until it was buffed out. It was 4 cyl car that got a windsor swapped into it with a tremec, 8.8, cobra disc brake conversion, suspension, ect ect ect.
/end thread hijack
/end thread hijack
Chris Hansen
Club Member
Just some pictures I snapped today after I rolled it out of the shop to clean.
trigger
Club Member
Car has been transported to the local speed shop that myself and Chris Hansen work at. I had a bit of a falling out with the guy who was doing the rollbar in the car. The car is sitting with a semi tacked in rollbar right now. We will have the engine and transmission back in the car this weekend and the rollbar will be fully welded in shortly.
