1990 Mustang...

smooth said:
What did you put on the cage?
Click to expand...

I used the Chassis Saver I had left over in gloss black... I did rush the job big time though... But even in the area's I did a nice job in... It bubbled bad... So I took the grinder to it and start stripping the cage... Then I was told about aircraft remover... So I ordered that and going to use that instead... Hopefully it just wipes right off...
 
ReiKo said:
I used the Chassis Saver I had left over in gloss black... I did rush the job big time though... But even in the area's I did a nice job in... It bubbled bad... So I took the grinder to it and start stripping the cage... Then I was told about aircraft remover... So I ordered that and going to use that instead... Hopefully it just wipes right off...
Click to expand...

Yeah get some 150 grit and scuff the cage by hand just enough to get a scratch in the chassis saver, then go over the cage with some Aircraft stripper and it should get the majority of it off. I usually get a 4" bondo scraper to get it off, just fyi if you have and old fashion syphon gun spray the ACS on...it works better than brushing it on :handshake:

I can get you some high/semi/low gloss single stage black lmk
 
smooth said:
Yeah get some 150 grit and scuff the cage by hand just enough to get a scratch in the chassis saver, then go over the cage with some Aircraft stripper and it should get the majority of it off. I usually get a 4" bondo scraper to get it off, just fyi if you have and old fashion syphon gun spray the ACS on...it works better than brushing it on :handshake:

I can get you some high/semi/low gloss single stage black lmk
Click to expand...

Thanks...

No more Chassis Saver... Going to strip it and scuff it nice... Primer it and hit it with a flat black and flat clear... And go from there...
 
just use sem trim black or similar, nice finish and easy touch up if you scratch it. no sense in bc/cc it if its not a show car.
 
smooth said:
Yeah get some 150 grit and scuff the cage by hand just enough to get a scratch in the chassis saver, then go over the cage with some Aircraft stripper and it should get the majority of it off. I usually get a 4" bondo scraper to get it off, just fyi if you have and old fashion syphon gun spray the ACS on...it works better than brushing it on :handshake:

I can get you some high/semi/low gloss single stage black lmk
Click to expand...

you can get the aircraft remover in a spray can......
 
You must log in or register to reply here.
Back
Top