What should this run...

MotorCityNova572

MotorCityNova572

Club Member
1994 camaro z/28 3500 lbs

4.10 gears
3500 stall
200 hp wet shot

lt1

12.5 compression

cam - 236/242 .560/.560

Heads are GTP Stage 2 with the following flow
Intake
.200=131.6/44
.300=188.4/63
.400=233.3/78
.500=262.6/87.8
.600=263.2/88
.650=256.6/85.8
.700=256.0/85.6

Exhaust
.200=109.5/34
.300=148.1/46
.400=175.5/54.5
.500=193.2/60
.600=202.8/63
.650=204.4/63.5
.700=206.1/64

and of course all the headers and exhaust stuff.
 
not knowing the cams CL and LSA numbers makes a bit of differance in the numbers the combe "could/might" put down...

Thats a baby cam with those dur and lift specs in a LT1 but 10.8's is do able.
Theres more to it than just basic build spec you called out nick.
*How tight did they set up the quench area?
*How big are the combustion chambers?
*What cc are the intake ports? ... bigger is not better on a 4.030 bore LT1.

3500 stall but what stator ratio? and what trans? 4l60e,t350,t400???
With a 4.10 gear I would thing it's a overdrive trans.
If it were a 3 speed the car would need at least a 4.33 gear to get off the starting line.
Hows the car set up for shocks? dose the car leave the linelike a slingshot or waist energy extending to the travel limits of the shocks extension then move forward? ...I hope not for his sake, 10's will be hard unless theres an abundance of raw HP(600+at the tire) is on tap without a chassie that works well.

you get the Idea
 
Last edited:
You must log in or register to reply here.
Back
Top