What kind of power?

KENNEBELL2.6

KENNEBELL2.6

Forum Member
What kind of power do you think my car will make. 4.6 2 valve, pi heads, crower stage 2 cams(dont know the numbers), steel cobra crank, forged rods and pistons 10:1 compression with a 2.6 KB at 10 - 12 lbs? I really dont know what to expect Ive never had a boosted car before only a 100 shot of nitrous. Thanks
 
I would love to do that but the motor was done a year ago when I had no intentions of doing this. So when it blows up I will definatly do that.
 
KENNEBELL2.6 said:
I would love to do that but the motor was done a year ago when I had no intentions of doing this. So when it blows up I will definatly do that.
Click to expand...

Just keep it cool and run good plugs and gas.....it will be fine unless you get crazy with the psi.

--Joe
 
Depends on the dyno. A roots blower is going to eat power. I would say this might be comparable to an upgraded pulley 4.6 dohc cobra motor. Depending on whose dyno it gets on could be anywhere from 420-500hp.
 
my car just made 430 on a mustang dyno with a built motor vortech v1 and 10-11 lbs

I would say close to 500
 
I had a feeling it was the helix vs the lobe. Yeah the helix is alot better by far then a roots. I didn;t take the comment personally. If its Lidios dynojet I will go with between 460-500


soap said:
Not debating that. I was just correcting your roots blower comment.

--Joe
Click to expand...
 
Last edited:
You must log in or register to reply here.
Back
Top