What do i need to polish a supercharger?

3 inch die grinder 36 grit to take off the edges (seams) the brown pad(gasket remover type) 3 inch rolocs for smoothing the rough casting.. then take a DA a work your way from 80 grit to 320 dry and then hand sand 400-2000 wet. In between each sanding stage use a "Guide-Coat" flat black spray paint (not gloss) misted over the entire thing lightly (it will show up your scratches on the previous grit. Then when its wet sanded in 200 you can use mothers aluminum polish or Simi-chrome (by power tool and wool pad works best) then wipe clean... bling blaaang!
 
MystryGuy said:
3 inch die grinder 36 grit to take off the edges (seams) the brown pad(gasket remover type) 3 inch rolocs for smoothing the rough casting.. then take a DA a work your way from 80 grit to 320 dry and then hand sand 400-2000 wet. In between each sanding stage use a "Guide-Coat" flat black spray paint (not gloss) misted over the entire thing lightly (it will show up your scratches on the previous grit. Then when its wet sanded in 200 you can use mothers aluminum polish or Simi-chrome (by power tool and wool pad works best) then wipe clean... bling blaaang!
Click to expand...


thanks,
 
veery niice, i'll bring mine over in a minute :), it's already polished but it needs some rubbin!
 
foncarelli said:
Do you have a power pipe? If so, do you have a blowoff mounted to it?
Click to expand...

yeah i have a power pipe, but vortech has a different b.o. setup, i was thinking about getting a mondo and setting it up like a procharger.Maybe i'll swing by abd see how your set up is?
 
You must log in or register to reply here.
Back
Top