Tremec 3550 bellhousing to trans mount hole dimensions

[avbcon12]

anyone have the dimensions from hole-to-hole? i need to make sure this lakewood bell I have will mate to my 3550 before i tear it apart.

Thanks

 

[93-bucket]

I got my 3550 from D&D, maybe give them a call and see if they would know...

 

[avbcon12]

yeah I will tomorrow when they are open but i was hoping someone knew or had one laying around today. thanks though!

 

[93-bucket]

np

 

[sidewayscoupe]

I have one in the garage wait a minute.

anyone have the dimensions from hole-to-hole? i need to make sure this lakewood bell I have will mate to my 3550 before i tear it apart.

Thanks

 

[avbcon12]

Dan,

If it helps to use this image and draw measurements be my guest

thanks!

 

[sidewayscoupe]

Here you go

8.5" side to side
6.25" top to bottom

Keep in mind this was done with a tape measure.

 

[avbcon12]

Dan, thanks a ton! could you measure diagonals too?

 

[avbcon12]

now anyone have a dial indicator I can borrow to install/align this thing?! mine just broke.

 

[sidewayscoupe]

10 5/8" across the diagonals

Dan, thanks a ton! could you measure diagonals too?

 

[sidewayscoupe]

I have one with a magnetic base that you can use.

now anyone have a dial indicator I can borrow to install/align this thing?! mine just broke.

 

[avbcon12]

excellent, thanks a lot!