hangemhigh
Club Member
good looking bro!.....:thumbsup:
TEAM Z FOX COUPE BUILD-UP
- Thread starter Pwraddr
- Start date
JoeP.
Club Member
Last edited:
Pwraddr
Forum Member
$925....you interested in a set?
Pwraddr
Forum Member
Update: Just hung up with Gil @ Speedwire....what great customer service! He called me tonight after hours to discuss the rest of my set up...spoke to him for an hour!!!
My switch panel and relay board is good to go and he is just getting all the connectors, switches and wiring in order and then will ship.
He has done everything so far without any deposit! I can't wait to get the stuff and would encourage anyone that is interested to give him a call.
My switch panel and relay board is good to go and he is just getting all the connectors, switches and wiring in order and then will ship.
He has done everything so far without any deposit! I can't wait to get the stuff and would encourage anyone that is interested to give him a call.
Pwraddr
Forum Member
hangemhigh
Club Member
nice stuff keith. maybe i misheard you. street car, right?......:buds:
Pwraddr
Forum Member
Yep!
Pwraddr
Forum Member
Thanks for your help on the YB.
Yeah, I looked at the Schoneck and it was too racy (is that a word?) for me. I really like the factory cover so it was pretty easy for me. Did you get the short or the long version?
JoeP.
Club Member
I have the short design Schoneck LX bumper.
Pwraddr
Forum Member
Yep...I was thinking of that one....but I really like the factory piece. You got carbon too, correct?
I am cheap so I got glass. The nose weighs 13 pounds....you weigh yours?
JoeP.
Club Member
I ordered the front bumper and the 5" cowl hood extended to the windshield both in fiberglass(I'm somewhat thrifty myself). You had me thinking, I never did weigh them so I just went out in the garage to check. The bumper has the front fender extensions moulded into the design, and weighs 13.4lbs. The hood is 13.1, but I may end up trimming off the extended cowl at the rear edge of the hood. With the cowl scoop at the windshield it blocked too much view for my liking.
Pwraddr
Forum Member
Interesting....mine does not have the fender extensions.
I also ordered a 6 inch hood to windshield from SKRCs, Joe Van O makes it. Also a pin on deck lid from him too. Should arrive this week.
I worried about the view too, but the one I got starts to taper back down at the windshield....that is why I got it!
BTW, I weighed the stock nose with the lights in it and it was 27.
Pwraddr
Forum Member
UPDATE:
Recieved everything from Speedwires today. Gil is top notch and I would recommend anyone in need of a set up to contact him.
Mil spec bulkhead connector
Flame retardant sheathing
Wire
Weather pack tool, removal tool and battery lug crimper
Heat shrink, connectors, bag of different weather packs, mil spec starter relay and some misc stuff
Switch panel, relay board and aux board for fuel pump and associated cables
http://gallo-teck.ca/speedwire/ Gil Zenari
Recieved everything from Speedwires today. Gil is top notch and I would recommend anyone in need of a set up to contact him.
Mil spec bulkhead connector
Flame retardant sheathing
Wire
Weather pack tool, removal tool and battery lug crimper
Heat shrink, connectors, bag of different weather packs, mil spec starter relay and some misc stuff
Switch panel, relay board and aux board for fuel pump and associated cables
http://gallo-teck.ca/speedwire/ Gil Zenari
Last edited:
