Sn95 manual to auto swap

dave89iroc

dave89iroc

Club Member
What all parts would be needed to swap a automatic into a manual car? It's a v6 car


Trans, flexplate, shifter and cable, crossmember? Driveshaft? Harness? computer?
 
Good trans cooler
trans cooler lines
Baumann Electronic Controls makes a nice trans control unit for auto swaps.
If you get an auto cpu I'm pretty sure your going to need a tune.
Because its a manual car an auto shifter wont be a direct fit. I got a B&M hammer shifter to work in mine with minimal fab work.
 
If the car was available with the auto and there is a PCM production available for it, I'd use that before going stand alone.
 
Also you need to figure out what speed sensor & speedo gear will work with the new auto trans. What auto trans do you plan to go with?
 
If you get a manual valve body there is no need to mess with the computer/controller.

--Joe
 
You must log in or register to reply here.
Back
Top