Parts for Sale, Holly MI

Fryguy302

Club Member
Precision Billet 98mm CEA Turbo, g-trim, 1.32 a/r exhaust housing, low passes, made 2000hp on small block, $1950obo

Comp Cams Solid Roller Lifters for SBF, stock diameter, used but not much time on them, good shape $200

TFS Twisted Wedge Heads, with roller rockers, no port work, set up for hyd roller lifters, $1100 obo

Shorty headers for BBF, fits 70's trucks and others, stainless, $250

Edelbrock EFI 5.0 intake for 302, *lower intake only* can be used with Edelbrock upper or Pro Products uppers, $75

Pro Products billet TFI/EFI distributor for 302/351 (two bases), $100 shipped.

DSS 351 short block, forged pistons, girdle, ARP Hardware, very low miles but needs some clean up as it sat around a while.

Hooker Super Comp Headers and dual exhaust for SBF in early mustang or comet, $200obo

Rage head and neck restraint, cost $600+, will sell for $300obo

Edelbrock Super Victor intake manifold for 9.5 deck SBF, 4150 flange, (2924), $200

Racecraft Weld-on Caster/Camber plates also brand new, never used, $100

Solid Roller Cam for SBF, like new, idle time only, 268/282 deg duration @ .050 lift, .721/.704 lift, 112 lobe sep, $150

DFI Gen 6, old school EFI box with harness for Turbo V6 Buick, $250

13-14 Mustang GT mufflers and tailpipes, removed from brand new car, less than 10 miles, $50obo

65 Comet front and rear bumers, good shape, $150 for both

65 Comet hood, holes for pins but no rust ever, $100


Everything below this line is between Free and $25
______________________________________________________________________________
70 Cougar gas tank, good shape, $25
65 Comet Rear Seat, needs cover, $20
70 Cougar/Mustang Power Steering Pump, was on 351c, (free)
70 Cougar/Mustang 351C air filter assembly, $20
87 Grand National Header Panel (needs minor repair), $25
2010 Mustang Wiper arms, motor, etc, $25
2010 Mustang box of misc. parts, stock airbox, etc, $10
78-88 G-Body HVAC Block-Off panel, $20
LS1/LS2/LS6 stock rocker arms, low mileage $25
 
Last edited:
Back
Top