408w 10.7 to 1 motor, 69 block converted to HYD roller (all pro machining), All Forged bottom end JE custom coated pistons tool steel wrist pins, w/new Total seal rings, Eagle H-Beam rods w/arp 2000 bolts, Eagle Lightweight forged crank, pro built/balanced rotating assembly, main girdles, All new arp studs, bolts,etc...all new gaskets, AFR205s done by Advanced Engine Airflow, all the good hardware, NEW Scorpion rockers/hardened pushrods, Victor jr, intake, Custom NOS cam, Billet timing set, Link bar Hyd, roller lifters, New Proform 950 carb freshly reworked by Evergreen carbs, Canton pan, etc.etc....Motor has gone consistent 10.50s in a 3155lb car on motor/pump gas, and 8.90s with a Dual shot cheater kit on C16....ready to drop in and run ALL Fresh!!!! ONLY $6900obo!!!
NOS 408 Motor ALL Fresh!!
- Thread starter Hard8s
- Start date
FLAGMANBILL
Club Member
how much did you spray each stage?
Bill,
Since I am the "ridiculous" guy over on Corral you are speaking of, and I can't seem to get a response from you on there or through e-mail, I am posting here on your hometown forums.
First off:
You havent responded to ANY of my messages since 11/7 when you said to me in a PM:
"Then why don't I just go pick you up the proper bellhousing and another shifter from D&D and send them to you and you can send that bellhousing and shifter back to me, and you will then still have an awesome deal!!! Because they're is hardly any use on that stuff at all..."
Before that on 11/7 you also sent me this message:
"I just got back in town about an hour or so ago, thanks for being patient. I will deposit money in the bank tommorow into my paypal account for your refund...It will take a couple days to become available in my paypal account but as soon as it does I will send your money back...When will you be shipping this back?? And you will be using Forward air again?? As far as the trans goes that is exactly how I purchased through the corral and it was to be for a modular motor mustang...I've never even taken it off the palet myself, and yes once I get it back again I plan on looking it over closer and verifying what the bellhousing is for...Let me know when to expect the trans and I'll let you know when the money is sent...thanks."
Funny how on Motown you say you bought the trans from Motown....
"I bought the trans setup from motown and never ended up using it at all!!"
Ad on Corral you say you bought it on Corral???
"As far as the trans goes that is exactly how I purchased through the corral and it was to be for a modular motor mustang"
How could you not know that this tranny and bellhousing was NOT for a Modular? It doesn't look anything like a modular bell as the starter is on the wrong side.
Also you said that you never claimed anything else in the thread or on the phone about the trans. Your post on Corral said the complete setup was NEW from D&D Performance and cost over $5000 dollars! You told me the same thing on the phone the day I sent the $2590 payment to you via Paypal.
New Viper Tranny? Bell? $1000 clutch? Hydraulic clutch conversion? Remember??
Not "like new" or "almost new" or "sort of new" or "was new." It sure as hell didn't say "used for less than 500 miles" in the for sale post until 5 days after I paid you for it.
How about a response???
I have tried to keep it private but your leaving me no choice but to make this a public issue. A response would be appreciated.
Since I am the "ridiculous" guy over on Corral you are speaking of, and I can't seem to get a response from you on there or through e-mail, I am posting here on your hometown forums.
First off:
You havent responded to ANY of my messages since 11/7 when you said to me in a PM:
"Then why don't I just go pick you up the proper bellhousing and another shifter from D&D and send them to you and you can send that bellhousing and shifter back to me, and you will then still have an awesome deal!!! Because they're is hardly any use on that stuff at all..."
Before that on 11/7 you also sent me this message:
"I just got back in town about an hour or so ago, thanks for being patient. I will deposit money in the bank tommorow into my paypal account for your refund...It will take a couple days to become available in my paypal account but as soon as it does I will send your money back...When will you be shipping this back?? And you will be using Forward air again?? As far as the trans goes that is exactly how I purchased through the corral and it was to be for a modular motor mustang...I've never even taken it off the palet myself, and yes once I get it back again I plan on looking it over closer and verifying what the bellhousing is for...Let me know when to expect the trans and I'll let you know when the money is sent...thanks."
Funny how on Motown you say you bought the trans from Motown....
"I bought the trans setup from motown and never ended up using it at all!!"
Ad on Corral you say you bought it on Corral???
"As far as the trans goes that is exactly how I purchased through the corral and it was to be for a modular motor mustang"
How could you not know that this tranny and bellhousing was NOT for a Modular? It doesn't look anything like a modular bell as the starter is on the wrong side.
Also you said that you never claimed anything else in the thread or on the phone about the trans. Your post on Corral said the complete setup was NEW from D&D Performance and cost over $5000 dollars! You told me the same thing on the phone the day I sent the $2590 payment to you via Paypal.
New Viper Tranny? Bell? $1000 clutch? Hydraulic clutch conversion? Remember??
Not "like new" or "almost new" or "sort of new" or "was new." It sure as hell didn't say "used for less than 500 miles" in the for sale post until 5 days after I paid you for it.
How about a response???
I have tried to keep it private but your leaving me no choice but to make this a public issue. A response would be appreciated.