Need sheet metal in NE metro Detroit

M

Motorcitydak

Forum Member
Hey guys, I need to get my hands on some sheet metal for some floor pan work and whatever else I need to make. Im work in clinton twp and live around marine city. Where can i get some 16 or 18 gauge metal from and what can I look to spend?
 
what size do you need, i used some for my floor pan , i think i still have some 11 x 17 sheets at home (i live in clinton township)
 
Basically as big as possible, I would guess a 4x4 section or two would do it. I have to build a pretty big dog house over the drivetrain, I have to build a dry sump oil pan as well.

Im pretty sure I know of that place you are talking about with the tim man, I just thought they only did HVAC ducting
 
Mike, I finally found the place you were talking about. It is called J&J Sheet Metal Products. I will have to call them and see if they offer sheets. I also mite make a poster board mock up and take it to them to see if they can just make me the pieces I need
 
Wanted to update this again with some info I have found. I emailed a place on Hall Rd in Chesterfield, Kehrig Mfg, address is 28151 Hall. They can sell quite a bit of different sheet metal for pretty good prices. The email said 18ga 3ftx10ft $50, 16ga 4ftx10ft $75 and 16ga 27 1/2x48 for $15. They can cut for $10
 
You must log in or register to reply here.
Back
Top