Mustang brake issue

slickstang said:
I am using the stock brackets and the rotors are off by about 3/4" the offset of the rotor is to deep.
the rotors are 10.5"
Click to expand...

so youre not using COBRA rear brakes, youre using v6/gt rear brakes. is the rotor solid (non-vented) liek the one i posted? if so its a v6/gt rotor, cobras are vented 11.65"

the concept is the same for both though, youll either have to get the NRC brackets or cut the stock ones like above. youll get that 3/4" back when moving the brackets to the inside of the axles mounting flange.
 
dont forget, youre also going to need a shim for the axle hub to make sure the rotors will turn true/ round because the hub on the axles are smaller diameter than the hole in the rotors.

something like the second item down:
http://discbrakesrus.com/make/ford/mustanggtff.htm

I just used 2.5" pipe with 1/8" wall tubing, cut a slit in it and slid it over the axles hub until it was snug. works just fine.
 
You must log in or register to reply here.
Back
Top