oharaautomotive
Forum Member
****Price adjustment******$$$5000 O.B.O. Also forgot to add this combo will come with headers for Fox body mustang and Al. driveshaft for the C4 and bolts up to a 8.8 rear end. basically everything you need to put in a fox body Mustang.
Motor is a 363 cu. in. 1969 351W block Bored 0.060" over
Eagle 4340 3.5" stroke crank
Eagle 6.2" 4340 H beam rods
SRP forged flat top piston
Total seal AP stainless ring pack (for NOS)
Vic JR.heads, Titanium intake & exhaust valves, retainers, locks etc, 2.09I and 1.6E, these are Brian Mitchell''s old heads, he won 3 championships in NMRA EFI renegade with these heads. Ported by Dan Rawls
Bullet cams custom cam solid roller built for this motor with a 250 max nitrous hit.
Bullet cams roller lifters
Super vic intake port matched to heads and inside cleaned up.
Pro Systems 780cfm 4150 style carb built for this motor
Trans is a C4 built by Mike Ridings, with a 9.5" converter built for Nitrous to stall at 4500, has trans brake installed.
The motor was gone through and assembled by Holbrook racing engines last year. I put it in and did not get a chance to run it last year. The motor is fresh, I think the rings are just starting to seat. I am going to be building a new motor and need this one gone.
I am selling the motor carb to oil pan minus the distributor and the trans with converter. This combo has been matched together for a stock suspension mustang around 2800lbs and a max hit of 250 nos on 28" tall tire.
Looking to get $5000 O.B.O. for the whole combo I do not want to part it out because it is all matched, I will offer this to MM members first if it does not sell then it will be going onto other sites.
I can supply cam specs to serious buyer.
pics to come Call (734) 324-0904 thanks ----Brad
Motor is a 363 cu. in. 1969 351W block Bored 0.060" over
Eagle 4340 3.5" stroke crank
Eagle 6.2" 4340 H beam rods
SRP forged flat top piston
Total seal AP stainless ring pack (for NOS)
Vic JR.heads, Titanium intake & exhaust valves, retainers, locks etc, 2.09I and 1.6E, these are Brian Mitchell''s old heads, he won 3 championships in NMRA EFI renegade with these heads. Ported by Dan Rawls
Bullet cams custom cam solid roller built for this motor with a 250 max nitrous hit.
Bullet cams roller lifters
Super vic intake port matched to heads and inside cleaned up.
Pro Systems 780cfm 4150 style carb built for this motor
Trans is a C4 built by Mike Ridings, with a 9.5" converter built for Nitrous to stall at 4500, has trans brake installed.
The motor was gone through and assembled by Holbrook racing engines last year. I put it in and did not get a chance to run it last year. The motor is fresh, I think the rings are just starting to seat. I am going to be building a new motor and need this one gone.
I am selling the motor carb to oil pan minus the distributor and the trans with converter. This combo has been matched together for a stock suspension mustang around 2800lbs and a max hit of 250 nos on 28" tall tire.
Looking to get $5000 O.B.O. for the whole combo I do not want to part it out because it is all matched, I will offer this to MM members first if it does not sell then it will be going onto other sites.
I can supply cam specs to serious buyer.
pics to come Call (734) 324-0904 thanks ----Brad
Last edited:
