LS1 heads, cam, Jesel rockers, solid lifters and intake combo

02 Silver Z

02 Silver Z

Club Member
Set up has about 25 passes on it. was good for 10.20's @ 134 in a 3,000+lbs. car on terrible 60ft. Made 460HP to the tire on a Mustang Dyno with a big sloppy converter and stock ECM. Selling as a combo because of extensive mill work to get everything to fit i also did some hand porting to match the intake runners better.

Heads = ET Performance CNC 11 deg. 240cc, BIG springs, Ti retainers, 2.10/1.62 valves 40cc chambers
Intake = Edelbrock Victor Jr. EFI, Accel 4150 flanged throttle body (1,200cfm I think), 60# injectors
Cam = Comp solid roller LS1 400R .715/.715 110LSA
Lifters = Morel solid stock dia.
Push rods = Trend 7.850 - .080
Rockers = Jesel shaft mount 1.7 ratio

Firm at $2,750.00 for everything.
PM or Email [email protected] with questions.
 
Last edited:
Possibly, but the intake wouldn't do anyone much good unless you had a set of LS1 heads with the SH!# milled out of them or if you were going to have spacers CNC'ed to make it work.
 
You must log in or register to reply here.
Back
Top