joestang
Club Member
[ame="http://www.youtube.com/watch?v=E8BwLl4yfdk"]Idle & Rev[/ame]
Its going to Stenod as soon as the ignition miss is figured out, and big thanks to Greg Powrie for his work and patience.
Combo is as follows:
Sportsman block (B50)
Forged crank, rods, pistons (10.5:1)
Canfield 195's
Victor 5.0 intake (port matched, upper extrude honed, inlet opened to 90mm)
Accufab 90mm TB and custom 4" intake tube
Accufab 1 3/4 longtube headers, 3 " hpipe, 3" Hooker aerochamber muffs (dumped)
Its not as pretty as many on here, but it should run decent and at minimum not look terrible
Its going to Stenod as soon as the ignition miss is figured out, and big thanks to Greg Powrie for his work and patience.
Combo is as follows:
Sportsman block (B50)
Forged crank, rods, pistons (10.5:1)
Canfield 195's
Victor 5.0 intake (port matched, upper extrude honed, inlet opened to 90mm)
Accufab 90mm TB and custom 4" intake tube
Accufab 1 3/4 longtube headers, 3 " hpipe, 3" Hooker aerochamber muffs (dumped)
Its not as pretty as many on here, but it should run decent and at minimum not look terrible
