GM LSA Blower w/ CTSV lid, LSA injectors & Throttle body

[NBFRC]

Used LSA supercharger which was a warranty replacement. Pulled for a worn coupler which has been replaced with a new solid coupler. Car had 46k miles when pulled. Supercharger is in good working condition. Also have a used ctsv lid w/intercooler brick, used LSA injectors and throttle body all from the same car.

$1,350 Items are located in Warren at 10 & mound.

call or text 989-787-2017

 

[NBFRC]

Pic

 

[jspec]

So what motors could this be used on? Just a CTSv?

5 seconds worth of research square ports LSA

 

[NBFRC]

So what motors could this be used on? Just a CTSv?

5 seconds worth of research square ports LSA

Yep, pretty much any ls motor which has the square port heads. There are a couple of different options for the front pulley drive, as long as you have enough clearance for the stock truck accessory spacing you should have enough room for the front belt drive.

 

[OnyxSSS]

have you seen one installed with truck accessories and not the expensive gm bracket??

 

[BlackHawkSniper]

This is for a ctsv only

 

[NBFRC]

have you seen one installed with truck accessories and not the expensive gm bracket??

here is an aftermarket setup about half the price of the gm drive kit which uses the truck accesories
http://www.lssimple.net/new-products-1/coming-soon-lsa-supercharger-k-accessory-kit

 

[OnyxSSS]

dang...that is way sweet. thanks.

 

[nitrousrick]

What would be needed to make it work on a first Gen cts-v?

 

[OnyxSSS]

Heads square port L92, LS3, and you might still not have the room in the front of the engine, this bracket uses the truck water pump spacing which is 1" further forward. I also think the AC would need to get checked.
you would need the fuel injector rail
You would need someone to tune for it
You would need to make a IC cooling circuit and mount the resistor and heat exchanger
there is probably more stuff you would upgrade over time (fuel pump, injectors??)