DannyDodge
Wishes he had a Honda Del Sol!
Robitronic 1/8 scale mantis
less than a gallon of gas ran through it, has a Jammin' pipe on it, original stock pipe comes with it, 2 bodys original and a hummer, replaced factory wing with a better carbon fiber wing, its ready to run for make reasonable offer
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXPHA6&P=ML
FEATURES: Chassis: Aluminum 0.12" (3mm) thick anodized red in color, with front and rear composite braces Drive: Four wheel shaft drive Engine: Axial .28 Spec 1s with pull starter, SG (pilot) crankshaft glow plug, slide valve carburetor, two stage foam air filter, fuel filter Exhaust: Polished aluminum tuned pipe w/header Fuel Tank: 5.1oz (150cc) with flip top cap Radio: 2-channel 27MHz AM with dual rate steering, steering and throttle trim and reverse, high torque laydown steering servo, charging jack on transmitter Clutch: 3-shoe, 13 steel tooth clutch bell Transmission: Single-speed Ball Bearings: Full set, sealed Shocks: Four oil-filled, with coil-over spring, hard anodized aluminum bodied 3.5mm shafts and 14mm pistons, aluminum 0.16" (4mm) thick shock towers Main Gear: 52 tooth Gearboxes: Sealed Differentials: Bevel gear, floating front and rear diffs, ultra low design for lower center of gravity Brakes: Dual disk Tires: Axial Terra-izer block pattern tread, width 2.9" (75mm), outside diameter 5.8" (147mm), inside diameter 3.1" (80mm) Wheels: White dish style 2.2" (56mm) wide, 3.5" (88mm) diameter, 17mm hex Body: Painted and trimmed truggy style with molded composite wing, color scheme is white and red with gray and black trim Bumpers: Front and rear composite, black in color Suspension: Adjustable, with rubber dampened hinge pin pivot points front and rear anti-sway bars Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle Steering: Bushing supported bell-crank with servo saver Warranty Period: Two year limited
less than a gallon of gas ran through it, has a Jammin' pipe on it, original stock pipe comes with it, 2 bodys original and a hummer, replaced factory wing with a better carbon fiber wing, its ready to run for make reasonable offer
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXPHA6&P=ML
FEATURES: Chassis: Aluminum 0.12" (3mm) thick anodized red in color, with front and rear composite braces Drive: Four wheel shaft drive Engine: Axial .28 Spec 1s with pull starter, SG (pilot) crankshaft glow plug, slide valve carburetor, two stage foam air filter, fuel filter Exhaust: Polished aluminum tuned pipe w/header Fuel Tank: 5.1oz (150cc) with flip top cap Radio: 2-channel 27MHz AM with dual rate steering, steering and throttle trim and reverse, high torque laydown steering servo, charging jack on transmitter Clutch: 3-shoe, 13 steel tooth clutch bell Transmission: Single-speed Ball Bearings: Full set, sealed Shocks: Four oil-filled, with coil-over spring, hard anodized aluminum bodied 3.5mm shafts and 14mm pistons, aluminum 0.16" (4mm) thick shock towers Main Gear: 52 tooth Gearboxes: Sealed Differentials: Bevel gear, floating front and rear diffs, ultra low design for lower center of gravity Brakes: Dual disk Tires: Axial Terra-izer block pattern tread, width 2.9" (75mm), outside diameter 5.8" (147mm), inside diameter 3.1" (80mm) Wheels: White dish style 2.2" (56mm) wide, 3.5" (88mm) diameter, 17mm hex Body: Painted and trimmed truggy style with molded composite wing, color scheme is white and red with gray and black trim Bumpers: Front and rear composite, black in color Suspension: Adjustable, with rubber dampened hinge pin pivot points front and rear anti-sway bars Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle Steering: Bushing supported bell-crank with servo saver Warranty Period: Two year limited
Last edited:
