Fox mustang rear axle width

DRAG-ULA

DRAG-ULA

Club Member
Anyone know what it is off the top of your head? Wheel mounting surface to wheel mounting surface, not housing width.
 
Its close to 59 11/44" (found it on a quick Google search and it sounds close to when I was researching for my 1969 8.8 swap. )

I can measure the 8.8 I have at home later.
 
I found this on Jalopy Journal

86 to 93 V8 mustangs 58.75"
90 to 97 Ford Ranger 58.75
94 to 2003 Ford Exploders 59.75
90 to 95 Aerostar 59.75
79 to 2002 crown vick 62.8"
 
That's what I found too, but don't know where those numbers are taken from. I'd guess from axle shaft flange to flange, seems kinda wide for just the housing
 
Turns out 68-70 'B' body Mopar is the right width too, and my buddy has an 8 3/4" housing & axles. Picking it up Sunday
 
Last edited:
Looks like you need something wider than a Fox. Don't forget SN-95's are 3/4" wider than a Fox and New Edge are 1.5" wide than a Fox.

--Joe
 
You must log in or register to reply here.
Back
Top