kovacs32
Nipple show-er
For Sale: 2003 Twin turbo Cobra coupe******UPDATED****
*********************UPDATED****************ALL INFO***************
Posting for a buddy of mine, He really doesn't want to sell the car but hes about to have twins of a different kind and he doesn't want a car payment anymore. These are the mods the car has, there may have been a few he cant remember, but you get the point.
NEVER WRECKED OR IN ACCIDENT!
-2003 Cobra coupe, silver in color. just under 12,000 miles
-HP twin turbo 57mm kit all jet hot coated from headers, to turbos and back to the Hpipe.
-HBC Manual Boost control (inside of the vehicle).
-01 cobra upper and lower intake manifolds
-60 pound fuel injectors, CPR billet aluminum fuel rails, all braid fuel lines to back of the car, billet aluminum high flow 100 micron fuel filter.
-Twin Ford GT super car fuel pumps, Zone 5 fuel pump driver module. Fuel system is powered by 8 gage custom wiring setup.
- Kenne Bell Boost A Pump
-Kenne Bell Boost A Spark
-SCT custom tune, SCT Excalibrator 2 programmer
-3.5 inch Pro-M Blow through Mass Air Meter
-AEM digital readout wideband setup
-Autometer fuel pressure and 30 IN/!b boost gauge
-Fidenza Aluminum flywheel WITH replaceable center section
-RAM HD 900 clutch and pressure plate
-Liberty built T-56: 26 spline input shaft, 31 spline output shaft, (extension housing bored), ALL hardened blocking rings and keepers, ALL NEW BEARINGS, New syncros, NEW 1-2-3-4 Gears, Different 5-6 gear ratios, All trans components are Micronized treated.
-Mark Williams drive shaft yolk
-D&D billet short throw shifter
-Custom made Subframe connectors
-Steeda adjustable camber/caster plates
-QA1 tubular K-member and A arms
-QA1 Adjustable front coil over setup
-Ken Brown rear diff. brace
- Air lift adjustable rear air bags
-3:55 rear Gear
-Ceramic coated H pipe
-Borla stinger catback
-Cobra floormats
-Mickey Thompson 17 inch drag radials
The car made 748RWHP and 826 TQ on its last dyno pull. He has only had one decent run at the track but due to it being stock IRS and half shafts he left from idle and just took it easy down the track, NO powershifts, did mid 11's @140mph trap speed. This car was mainly a really fun street car for him, anyway hes looking to get $34,000 for it. If you are serious about buying this car please PM ASAP and i can get you in touch with the owner/seller.
thanks,
Ryan
*********************UPDATED****************ALL INFO***************
Posting for a buddy of mine, He really doesn't want to sell the car but hes about to have twins of a different kind and he doesn't want a car payment anymore. These are the mods the car has, there may have been a few he cant remember, but you get the point.
NEVER WRECKED OR IN ACCIDENT!
-2003 Cobra coupe, silver in color. just under 12,000 miles
-HP twin turbo 57mm kit all jet hot coated from headers, to turbos and back to the Hpipe.
-HBC Manual Boost control (inside of the vehicle).
-01 cobra upper and lower intake manifolds
-60 pound fuel injectors, CPR billet aluminum fuel rails, all braid fuel lines to back of the car, billet aluminum high flow 100 micron fuel filter.
-Twin Ford GT super car fuel pumps, Zone 5 fuel pump driver module. Fuel system is powered by 8 gage custom wiring setup.
- Kenne Bell Boost A Pump
-Kenne Bell Boost A Spark
-SCT custom tune, SCT Excalibrator 2 programmer
-3.5 inch Pro-M Blow through Mass Air Meter
-AEM digital readout wideband setup
-Autometer fuel pressure and 30 IN/!b boost gauge
-Fidenza Aluminum flywheel WITH replaceable center section
-RAM HD 900 clutch and pressure plate
-Liberty built T-56: 26 spline input shaft, 31 spline output shaft, (extension housing bored), ALL hardened blocking rings and keepers, ALL NEW BEARINGS, New syncros, NEW 1-2-3-4 Gears, Different 5-6 gear ratios, All trans components are Micronized treated.
-Mark Williams drive shaft yolk
-D&D billet short throw shifter
-Custom made Subframe connectors
-Steeda adjustable camber/caster plates
-QA1 tubular K-member and A arms
-QA1 Adjustable front coil over setup
-Ken Brown rear diff. brace
- Air lift adjustable rear air bags
-3:55 rear Gear
-Ceramic coated H pipe
-Borla stinger catback
-Cobra floormats
-Mickey Thompson 17 inch drag radials
The car made 748RWHP and 826 TQ on its last dyno pull. He has only had one decent run at the track but due to it being stock IRS and half shafts he left from idle and just took it easy down the track, NO powershifts, did mid 11's @140mph trap speed. This car was mainly a really fun street car for him, anyway hes looking to get $34,000 for it. If you are serious about buying this car please PM ASAP and i can get you in touch with the owner/seller.
thanks,
Ryan
Last edited:
