deputydog
Forum Member
SBC "184" casting bowtie block: 4.125 bore, roller cam bearings, bronze lifter bores, billet steel main caps, 1 sleeve installed at Roush Racing, block is set up for a external wet sump or dry sump but you can send the rear main to Program Engineering to have it drilled for a standard oil pump.
Nice block and one of the cheaper ones listed online that doesnt have the bores maxed out at 4.180+
$900
SBC 18 degree "363" hi port heads: CNC ported, titanium valves 2.180 intake/1.625 exhaust. used but in good condition, these are not used up NASCAR heads, no flow numbers but they were on a mild 400 that made around 740hp, no repairs or damage, no valve springs...also included is a fully ported GM "053" intake.
titanium valves cost over $1000 alone.
$1900
$2700 for block, heads and intake...may trade for BBC or 6.0 LS motor, let me know what you have, you never know.
Nice block and one of the cheaper ones listed online that doesnt have the bores maxed out at 4.180+
$900
SBC 18 degree "363" hi port heads: CNC ported, titanium valves 2.180 intake/1.625 exhaust. used but in good condition, these are not used up NASCAR heads, no flow numbers but they were on a mild 400 that made around 740hp, no repairs or damage, no valve springs...also included is a fully ported GM "053" intake.
titanium valves cost over $1000 alone.
$1900
$2700 for block, heads and intake...may trade for BBC or 6.0 LS motor, let me know what you have, you never know.
Last edited:
