Driveshaft length???

[fogule89]

have a ls swap fox body with a th400...how do i go about figuring out how long the driveshaft should be, i have a driveshaft but not sure on how to figure out length, do i measure from tailshaft to pinion or some other way? any help would be awesome thanks in advance

 

[87stang]

I measured from my yoke in my glide u-joint to the rear end yoke u-joint center's. I have a 1350 yoke for my 8.8 hope this help's or point's you in the right direction.

 

[soap]

have a ls swap fox body with a th400...how do i go about figuring out how long the driveshaft should be, i have a driveshaft but not sure on how to figure out length, do i measure from tailshaft to pinion or some other way? any help would be awesome thanks in advance

Depends on which company you decide to have make you the driveshaft. If you use Dynotech they have their own form which tells you what measurements to make.

http://www.dynotechengineering.com/downloads/1Pc Driveshaft with flange.pdf

--Joe

 

[FirecatF7]

I have used B&L Truck in Warren to make driveshafts for me.