Custom driveshaft

Arrow Truck and Parts
2637 W. Fort Street
Detroit, MI 48216
313-496-0900
Its a little north of you, but they make them in house to your specs and balance them. For roughly $250-$275, not bad at all. Hope this helps
 
Went to shaft masters today. They are good people my driveshaft will be done tomorrow. Thx for the tip guys!!

JP your chevelle is still on the wall in the office. Looks like a nice ride.
 
Just got my stuffback today couldnt be happier highly recommend shaft masters for any drive line needs!
 
I had a driveshaft done at Shaftmasters. The back flange was the wrong size when I went to put it in the car. Took it back and they charged me $50 to put on the correct one after I gave them measurements. Put the drive shaft in my car and I have 1/4 inch of in/out play in the trans. I take it back to Shaft me Masters and tell David whats going on and he tells me it should be fine. I tell him Ive heard you need around an inch of in out play where the yoke goes into the trans and he says that if we cut the driveshaft it will be wrong. I tell David to please cut about 3/4 out of the shaft and rebalance and whats it going to cost me know? (already got $400 into it) He sayes probably another $50 but he doesnt want to do it cause it will be too short. I say DOIT, he sayes well, Im going to have to go ask the boss. I finally grabbed me shaft and told him never mind. I live 40 miles away from these monkeys and just got sick of all the back and forth action. Just my expeirence take it for whats its worth.
 
johnyrrr said:
I had a driveshaft done at Shaftmasters. The back flange was the wrong size when I went to put it in the car. Took it back and they charged me $50 to put on the correct one after I gave them measurements. Put the drive shaft in my car and I have 1/4 inch of in/out play in the trans. I take it back to Shaft me Masters and tell David whats going on and he tells me it should be fine. I tell him Ive heard you need around an inch of in out play where the yoke goes into the trans and he says that if we cut the driveshaft it will be wrong. I tell David to please cut about 3/4 out of the shaft and rebalance and whats it going to cost me know? (already got $400 into it) He sayes probably another $50 but he doesnt want to do it cause it will be too short. I say DOIT, he sayes well, Im going to have to go ask the boss. I finally grabbed me shaft and told him never mind. I live 40 miles away from these monkeys and just got sick of all the back and forth action. Just my expeirence take it for whats its worth.
Click to expand...

If the mistake is from your information and measurements you will get charged. They explained in great detail how to perform the measurements. I have not heard of one being wrong yet?
 
You must log in or register to reply here.
Back
Top