Comp Cams SBC Solid Roller . . .

388Monte

388Monte

Resident Mouth
Brand New Comp Cams Solid Roller
If your building a Bad Ass SBC N/A Motor this is the car for you . . .

Comp Cam's Part#12-813-9

Adv. Dur - 306in 312ex

Dur @ .050 - .274in 284ex

Valve Lift - .747in 704ex

107' center line

5500-8000 Rpm

$250.00 obo
 
Last edited:
a383z28 said:
How much did you have to fly cut your pistons for that cam? on like a set of flat top pistons?
Click to expand...

I ran a simular cam to this one, I had the following pocket depths:

.320 In. .080 P to V
.260 Ex. .090 P to V

This is a great all motor cam, makes your small block sound like a pro stock.
 
Damn, I'd like to step up the one in my Jeep, but that's too much!! I need a better motor for that!
 
502SS said:
Damn, I'd like to step up the one in my Jeep, but that's too much!! I need a better motor for that!
Click to expand...

I have a simular cam that is a little bit smaller on the lift side, the dur is about the same. PM if your interested.
 
388Monte said:
Brand New Comp Cams Solid Roller
If your building a Bad Ass SBC N/A Motor this is the car for you . . .

Comp Cam's Part#12-813-9

Adv. Dur - 306in 312ex

Dur @ .050 - .274in 284ex

Valve Lift - .747in 704ex

107' center line

5500-8000 Rpm

$250.00 obo
Click to expand...
Do you think that thing will fit in my windsor, maybe then it will hall ass like that monte..
 
You must log in or register to reply here.
Back
Top