Car almost ready!

9

90blknotch

Club Member
Need to finish the exhaust after the headers, bunch of trans stuff, cooling system , get a drive shaft but the end is near!

0609012017a.jpg
 
Looks krispy.

Are those holes going to be occupied eventually or left not used along the strut/fender sheet metal section?
 
very nice, I am going to run the same intake on my turbo setup, if its anything like the old salleen it should love the boost.
 
Hey what did you do about your valve cover and blower tube? Does it touch? I know the Vortech one does. It's got it all cocked around. I even had Gautz cut some material off the cover and it still wasn't enough. I like that tube you have. I'd like to take a look at it or if you could get me some pictures that would be great. I'm soooo sick of this damn thing.
 
I had Gautz make one for the Blower to intake that went down further than the Vortech one - fits much better. I assume the one you are talking about is the blower inlet; I had Gautz make that one too and it fits barley. I am running stock cover though with shaft mounts - last year I was running girdels and the inlet would not fit not matter what I did so I ran with just a screen as it didnt see any street duty. I don't need MAF as its got the XFI though. I saw how your cover was cut and have seen other YS/YSi covers like that; I don't think there is a good way with a taller valve cover.
 
You must log in or register to reply here.
Back
Top