2011 F-350 Diesel Can-Bus

[Testaniracing]

I purchase a 2011 F350 Diesel and am trying to configure a dashboad monitor to see a handfull of channels

I am looking to configure the following and need to verify the pid's. Any help would be greatly appreciated
Engine Speed
Turbine speed
Outputshaft speed
Engine temp
Trans sump temp
Trans out temp

PM if you can help

 

[dave89iroc]

can that unit communicate on the can bus?

 

[Testaniracing]

yes it can. The channels above are not working correctly and I just want to verify the pids are correct

 

[dave89iroc]

yes it can. The channels above are not working correctly and I just want to verify the pids are correct

ahh, ok

how are the PIDs labeled in the units interface?

 

[GTPprix]

I believe all of those are SAE PID's so they should be in the SAE whitepaper...

 

[Testaniracing]

I believe the interface has it in this order(I will check the unit later) Channel ID, bytes, bits, length and multiplication factor.