1990 Mustang...
- Thread starter ReiKo
- Start date
Team Z Motorsports
Club Sponsor
That's ok I'm just messing with you!
twofast4you
Forum Member
the cars coming out good buddy and my hand hurts
ReiKo
New member
papa-bach-racing
Forum Member
car look good cant wait to see it
ReiKo
New member
blackstang
Club Member
Got the car back late last night... Don't have any more pictures of it but I will post more when I take some tonight...
Here's the fiberglass dash mounted...
thats a bad bitch
orangejuiced86
Club Member
Whats next on the list?
ReiKo
New member
Here's better and updated pics...
Parachute air cylinder
The parachute is a custom peice that's real thick so the cylinder tab was just welded right to it... Also a handle stop was welded in so the cylinder doesn't send the handle through the windshield... Or in the event of a failure if I were to slam on the handle I don't send my hand through the windshield either...
The fiberglass dash mounted and held in by dzus fasteners...
The top side of the dash where the pillar bars come down had plates welded around the bar so if I wanted to fill in the dash area and paint it I have some backing...
Here's better pictures of the dual parachute mount completely finished...
And the wheelie bars completed and mounted to the car...
Next on the list is to get the cowl cut out and make it a removeable one peice or I might just have it smoothed over... Also to get the engine bay ready to go under the knife...
Parachute air cylinder
The parachute is a custom peice that's real thick so the cylinder tab was just welded right to it... Also a handle stop was welded in so the cylinder doesn't send the handle through the windshield... Or in the event of a failure if I were to slam on the handle I don't send my hand through the windshield either...
The fiberglass dash mounted and held in by dzus fasteners...
The top side of the dash where the pillar bars come down had plates welded around the bar so if I wanted to fill in the dash area and paint it I have some backing...
Here's better pictures of the dual parachute mount completely finished...
And the wheelie bars completed and mounted to the car...
Next on the list is to get the cowl cut out and make it a removeable one peice or I might just have it smoothed over... Also to get the engine bay ready to go under the knife...
team_southside
Club Member
alot of work goin on there, lookin good though! who did all the fab work on it ?
hangemhigh
Club Member
def. looks bad-ass.......
