WTB: 2 channel amp!

Duke

Duke

Club Member
Looking for somehting in the 150-200 watt range just to power a pair of 6 1/2" Pioneer 2 ways. Would like somehting newer in good shape. The one I just got from a friend was DOA, don't want to go through wiring up another bad amp again!
 
ok you want 150-200 rated in newer power where they actually push 60-75 RMS or do you want old school power rated at 50x2 and push 150 or do you want old school rated at 150x2 and pushing closer to 300 per I have a ton of stuff as mentioned above, what are you looking to spend
 
I have an Orion 2150sx with a brand new harness...




that I just bought off moneypit and isn't for sale.

Buy from him. He knows his shit.
 
ok let me dig I have some 150x2 rms "rated" that actually meter close to 225 each channel

2 x 150W @ 4 ohms (12V)
2 x 210W @ 4 ohms (14.4V)
2 x 350W @ 2 ohms (14.4V)
1 x 700W @ 4 ohms bridge (14.4V)
THD: 0.015%
Damping Factor: 300
S/N Ratio: 105dB A-weighted
Dimensions: 13" x 9" x 2" (33cm x 22.9cm x 5
 
Last edited:
That first one you listed, the 2 x 150W @ 4 ohms (12V), would work perfect for this setup. What ya looking to get for it?
 
Duke said:
That first one you listed, the 2 x 150W @ 4 ohms (12V), would work perfect for this setup. What ya looking to get for it?
Click to expand...

That is the specs for one amp. Looks like a bit much to run a pair of 6.5"s but it would be good to use until you find another and then you can throw that at a good 12".
 
RBOD said:
That is the specs for one amp. Looks like a bit much to run a pair of 6.5"s but it would be good to use until you find another and then you can throw that at a good 12".
Click to expand...

That's 2X150 watt max right? Probably like 60 watts RMS or so, and I never run amps all the way up anyway. Should work perfect.
 
Duke said:
That's 2X150 watt max right? Probably like 60 watts RMS or so, and I never run amps all the way up anyway. Should work perfect.
Click to expand...


thats RMS rating

2 x 150W @ 4 ohms (12V)
2 x 210W @ 4 ohms (14.4V)

and its a under rated amp when I metered it last it was closer to 225 per channel at 13.8 volts
 
I have a old school alpine 4 channel works perfect just isnt very pretty its 45x4 could run it 2 channel figure 80 per channel 30.00
 
moneypit said:
I have a old school alpine 4 channel works perfect just isnt very pretty its 45x4 could run it 2 channel figure 80 per channel 30.00
Click to expand...
I might be getting this, I'm kinda wondering if it's my speakers blown and not my amp. Gotta test them out to be sure, I'll get back to ya,
 
If you want a 2 channel I have a couple small ones that I'll sell you for $30 and I'll take the 4 channel from Ken. One is an Alpine MRP-T406 which is 40w rms x2 and 90w peak. The other is a cheap 100x2 amp that is probably more like 60x2.
 
You must log in or register to reply here.
Back
Top