Through the floor SFC's fox body

smooth

smooth

Club Member
What does something like this cost? Not looking to do it myself, I have no welder & am not the best fabricator :lol:
 
I don't think Team Z is that far from you just depends on how busy they are and how fast you want it done. Looks like the team Z kits are about $225 for parts I'm not sure what labor would cost you but if you rip out most of the interior out yourself I don't think it would be that bad.

I was going to have him put them in my 94 but I already had a cage in the car thats tied into the subframes already on the car.
 
How about Gilsbach race craft in Westland? That's closer to you! Dave at TeamZ is almost in your backyard I think
 
Prolly $500 at the cheapest for someone to do that. More likely $600-$800 I'd imagine.

We did them in my car and I'm no fabricator, I know you could handle it for sure! The cutting is easy, just hoe work, lol. Take a little time to fit everything up properly, make some 6" x 6" plates for outriggers to mount to, and .125" wall 2" x 2" and 3" x 2" tubing. Prolly $80-$100 in materials. Get hooked up with Ryan, and weld away!
 
We did mine in my garage and I am no fabricator either. I bought my material from Van Huron Steel in Belleville and it cost around $75 for the material and took about three days at a few hours a piece to complete.
 
I have through the floor sub frames on my LX, along with jacking rails. They were done in CA, so I don't know what you could expect to pay for them here in MI... I assume more than $1K.
 
smooth said:
I'll drop my car off when your ready :lol:
Click to expand...

Lmao, dude you can figure it out I'm sure, go buy the material, there are a couple of holes in the floor you can stick your finger in and feel the frame, its exactly 2" wide, use a cut off wheel and cut the floor on the inner edge of the frame towards the front, then you gotta make room where the seat humps are, lay your steel down and have someone weld, then cut 2 pieces on a 45 for the backs and 2 straight for the front and weld in, your done.....
 
Cost me around 50 bucks to do mine and thas only cuz i had to fill the damn bottle on the welder thanks to the lil bro leaving it on...


I'm insanly busy right now but if you want them done in a few weeks I'd do them for ya..
 
You must log in or register to reply here.
Back
Top