cobrarwanab
Club Member
Anybody running a painless 12crt pro street harness in their fox? If so what wiring diagram did you refer to? I am running a carb set up w/ msd ign on my 85GT along with 8 switch panel
Painless 50002 pro street witing kit in mustang
- Thread starter cobrarwanab
- Start date
cobrarwanab
Club Member
Does anybody have a link to wiring diagram for the stock 85 headlight, turn signal, and wiper switch?
QuickLX
Club Member
I have both of the items from painless that you are refering to. As for the column in a fox body, i looked and asked...got no help.
Best thing I can tell you is check for continuity, it takes time but you definately know whats what when you are done. I think I still have everything labeled, and I have a tilt column out of an 88 or 89 I believe. I am not sure of the difference but I can check for you and let you know.
Best thing I can tell you is check for continuity, it takes time but you definately know whats what when you are done. I think I still have everything labeled, and I have a tilt column out of an 88 or 89 I believe. I am not sure of the difference but I can check for you and let you know.
cobrarwanab
Club Member
Did you add any additional fuseable links on the incoming power to the block. My kit did not come with instructions but I downloaded a copy. Will a small section of smaller gauge wire between the fuse block and battery+ safely serve as protection?
QuickLX
Club Member
The instructions for the wiring of the fuse panel to the switch panel is actually pretty good. If you follow it verbatim you should be fine. As for the use of addition fuses prior to the fuse panel I am not sure you need anything, but I will check that as well. Sorry for not having the most direct answers right now...I wired the car back in 2003 and haven't look at any of it since. LOL
cobrarwanab
Club Member
No need to apologize. Any help is appreciated. You have a pm