Nitrous feed line

82bird

82bird

Forum Member
My buddy made me this hose a while ago, its -6 braided hose with the teflon lined inside and hydraulic crimped fittings on the ends. My question is will this be safe to use for feed line off my bottle?
 
Sounds like it is properly made. Got a pic of the crimp fitting used ? Should be fine. Most of those crimp fittings are rated for 3500+ psi.
 
ill get a pick tonight. I just didnt want this thing blowing apart halfway down the track... yikes
 
82bird said:
ill get a pick tonight. I just didnt want this thing blowing apart halfway down the track... yikes
Click to expand...
if it was going to blow apart, itd do it when you werent spraying, as the line pressure is highest when youre holding the pressure up against the solenoid and the bottle is open and warm. when it starts sprayng, the line pressure drops
 
well so far i tested it out in the garage, my bottle is low and only got 700 psi reading on the gauge, line held up to that... should hold at 1,000 psi? Well like sean said these style lines usually hold up to 3500 psi so i should be safe right?
 
You must log in or register to reply here.
Back
Top