Mustang Quarter Panel

[NTAHORS]

I have been able to find entire Mustang Quarter Panels, But I am wondering if any one knows of a supplier for just the part I have highlited in the pic below.

Or even if some one had a car they were parting out that had this section clean..

Thank You
- Corey

 

[orangejuiced86]

Sherman & Associates might have what you are looking for.

http://www.shermanparts.com/

 

[PaxNovi 5.0]

Been there, done that. I also looked for just than panel, but had no luck. You'll have to find a clean one someone has, and cut off the section you need.

Make your cut right where the molding goes, and it'll never been seen once you weld up the new piece. It's in a good location for that purpose.

Make sure you get the inner part as well, as chances are that has cancer as well.

Good Luck!

 

[orangejuiced86]

That small of a piece and that flat you could get some flat steel and make the panel yourself.

 

[FiveFour2000GT]

http://cgi.ebay.com/ebaymotors/79-9...ptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories


I do have the pass side brand new

 

[NTAHORS]

That small of a piece and that flat you could get some flat steel and make the panel yourself.

Yeah problem is that it is rusted around to the lip as well...

 

[mikesfastss]

there is a capri at parts galore

 

[NTAHORS]

there is a capri at parts galore

Which location ? only thing that sucks is there is no Air or electricity to use a saw or grinder ...

 

[NTAHORS]

Make your cut right where the molding goes, and it'll never been seen once you weld up the new piece. It's in a good location for that purpose.

Good Luck!

Yep that was my though exactly, hence where I have my red line in the pic..

Thanks

 

[mikesfastss]

Livernois and warren.I take a small generator and cut off wheel.I cut a whle trunk pan out of a monte carlo like that.good times,lol

 

[jordanbmx]

phils auto slavage or junkyard whatever... on dix road just south of eureka has like 8 foxbodys as of lastweek i dont know the condition of them tho

 

[orangejuiced86]

I dont know, you did a good job on the engine bay, I think you have the skills to make that piece if you cant find one.

 

[1BADAIR]

gas cement cutter will cut one off at a junk yard

 

[hangemhigh]

sherman should have that. i've got a rh repair panel for my '91 that came from them.

 

[91Notch]

I just a NOS LH rear quarter for sale for a Capri

If you get that piece make sure it's 79-90 and not 91-93