Jig_Chucker
Forum Member
Trans and everything else listed is SOLD!!!!! Thanks Motown....
I have a JPT Built full roller C4 trans for sale, It was recently freshened up by Accurate trans in Belleville, MI and has less than 3 - 1/4 miles passes and less than 100 street driven miles since it was freshened.
The trans has the following parts and upgrades installed-
(This trans is very much similar to the PA super comp C4 but does not have a transbrake)
Full Reverse manual VB
Hardened input shaft
PA Billet servo
Deep trans pan
Lokar C4 braided dip stick tube
Aluminum Bellhousing
Solid aftermarket Trans Mount
PTC 9.5" 3500rpm Stall converter that was setup for a 302-347 street car with a Turbo running 12-15lbs of boost and had anti balooning plates.
I am also including a B&M Hammer shifter and C4 Cable Kit that fits into the center console of Fox body mustangs.
Also included is the B&M Trans cooler with Aeroquip -6 Feed and Return lines with all fittings, etc that is ready to install!
I am asking $1,500 for everything listed, the only thing you would need to install this in a car is a 157T flexplate with the proper balance for your engine. Trans is located in Canton, MI PM or email me at [email protected] I will have pics up tomorrow evening of everything.. Thanks
I have a JPT Built full roller C4 trans for sale, It was recently freshened up by Accurate trans in Belleville, MI and has less than 3 - 1/4 miles passes and less than 100 street driven miles since it was freshened.
The trans has the following parts and upgrades installed-
(This trans is very much similar to the PA super comp C4 but does not have a transbrake)
Full Reverse manual VB
Hardened input shaft
PA Billet servo
Deep trans pan
Lokar C4 braided dip stick tube
Aluminum Bellhousing
Solid aftermarket Trans Mount
PTC 9.5" 3500rpm Stall converter that was setup for a 302-347 street car with a Turbo running 12-15lbs of boost and had anti balooning plates.
I am also including a B&M Hammer shifter and C4 Cable Kit that fits into the center console of Fox body mustangs.
Also included is the B&M Trans cooler with Aeroquip -6 Feed and Return lines with all fittings, etc that is ready to install!
I am asking $1,500 for everything listed, the only thing you would need to install this in a car is a 157T flexplate with the proper balance for your engine. Trans is located in Canton, MI PM or email me at [email protected] I will have pics up tomorrow evening of everything.. Thanks
Last edited:
Here here the links below to them at Summit.. I may also consider seperating the shifter, Trans Cooler, Converter, etc..
