GN guys HELP!!!

88ls1blazer

88ls1blazer

Club Sponsor
I need a fuel pump sender/holder for my buick with intact OEM wiring, or upgraded wiring. I dropped the tank on the buick yesterday and all of the wiring to the pump is torched, It is a digital dash car.

I dont need a pump.

Thanks,

Andy
 
Not sure if this helps you at all, but I have a complete used gas tank with sender/holder and 255lph pump. No wiring on it.
 
I'll have to check it out when I get home and get back with you. I have no idea if it was from a digital dash car though, we basically bought all the parts that were left over from a GN that was being converted to an outlaw 10.5 car years ago.
 
Snap a picture. Might be able to put a mil spec fuel/fluid proof wiring bulkhead in the sender. I have done that in the past with difficult to locate senders with wiring problems.


88ls1blazer said:
I need a fuel pump sender/holder for my buick with intact OEM wiring, or upgraded wiring. I dropped the tank on the buick yesterday and all of the wiring to the pump is torched, It is a digital dash car.

I dont need a pump.

Thanks,

Andy
Click to expand...
 
Specmo is great @ fixing GM wiring, I have had them repair quite a few OE GM parts, the next thing will be to get them to fix my U52 boost sensor for the digital dash on my buick :D one can only hope
 
no sir, that uses a 2bar MAP sensor, the digital dash cars have a yellow light for "low boost" and a red light for "high boost"
 
You must log in or register to reply here.
Back
Top