90blknotch
Club Member
Old exhaust off my car - these did not fit with my new oil pan! Hooker Supercomp 1 3/4" headers with adapter plates - they have been cut to fit a Victor Jr port but can be redone for others. The tubes are slip fit on both sides and they have a 3" collector. Also included is a Dr. Gas 3" X pipe with flanges for these headers and 3" Dynomax bullet race mufflers. Its loud - probably not streetable.
My car had a 8.2 deck 302 stock pan & C4 with JW bell and a QA1 K member - I know they fit this combo. I had issues with my new oil pan - its a 10qt Canton aluminum Pro Pan so its super huge. I think by part number these are for a Windsor in a Fox but they worked fine on my 302 - I did have the tube that goes around the steering shaft lengthened for a better fit. That tube was not re-coated but could be as it is a separate piece.
This setup is well over 1K new - looking to get $500 for all of it. I will split if anybody wants it $375 for the headers $150 for the rest.
Email [email protected] or 734260083two
My car had a 8.2 deck 302 stock pan & C4 with JW bell and a QA1 K member - I know they fit this combo. I had issues with my new oil pan - its a 10qt Canton aluminum Pro Pan so its super huge. I think by part number these are for a Windsor in a Fox but they worked fine on my 302 - I did have the tube that goes around the steering shaft lengthened for a better fit. That tube was not re-coated but could be as it is a separate piece.
This setup is well over 1K new - looking to get $500 for all of it. I will split if anybody wants it $375 for the headers $150 for the rest.
Email [email protected] or 734260083two
Last edited:
