Blower belt alignment issue

[x4bngr]

I have an issue where my blower pulley (cog, if it matters) is out of alignment with my crank pulley. I don't want to chew up cog belts at $125 a piece.

I know there are pulley alignment tools (laser). Unfortunately they start at about $500.

Any low-tech suggestions on how to align the blower puller, idler pulley, and the crack pulley would be appreciated. If I could find the appropriate laser (line, not point) I might try to rig up a tool on my own.

Unfortunately, I should have done all of this when the motor was on the engine stand in my Dad's garage.

Thanks.

 

[avbcon12]

straight edge (steel rule, etc) works just fine.

 

[WhiteHawk]

There is a place in Indiana (Dynotech maybe?) that specializes in lining up pulleys. They did it for Torxilla and it stopped his belt shredding completely. Probably not super cheap though.

-Geoff

 

[Sean]

Is it driveable ? I can take a look at it and see what can be done with some basic machining.

 

[1bad Lad]

u can get a laser for less than 500......i think more like 150ish...i may be wrong but 500 is rediculous