86iroc305
Forum Member
So never fails going to put the intake on a motor and run into a couple issues. The valve covers go on fine, but once the intake is on theres not enough clearance to get them off, this also turns into my second problem if the intake is on i can not get the valve covers on. So I was thinking of running a smaller rocker to allow the valve covers a little more wiggle room. This is on a Sbc with a Accell Superram, standard big body aluminum 1.6 roller rockers, and these valve covers http://static.summitracing.com/global/images/prod/large/pro-141-131_w.jpg So I was thinking of going to a stainless steel full roller rocker, I see these procomps fairly decent priced I was wondering if anyone has ran them before ? Or has some tips about the current setup .
