3rd gen rear springs

[82bird]

I hear alot of guys are running stock v6 springs with 1/2 - 1 coil cut. I already have v6 springs, i cut the top coil off and driver side sat good, but passanger was 1/2" higher. I eliminated the upper insolator, and used heater hose also. Triple checked posistioning and made sure springs were seated right. Can i cut a little more off right side to even out? I know it may change rates, just want some opinions

 

[Sean]

check your pinion angle and the panhard bar, if the rear is off center with alot of down angle in the pinion it will do that.

 

[82bird]

2 1/2 * neg. pinion angle, rear axle is centered. Im gonna get another set of springs and try them. Maybe the set i had were a little off