johnquick302
Club Member
rob is selling his motor and asked if i could put in online for him
here is what i know about the motor he is finding out the rest later from his engine builder
motorsport block was brand new at the beginning of the year it now has 1 sleeve in it
eagle crank
eagle rods
diamond dome pistons, .40 over 15to1comp
solid roller cam .630lift, [email protected], on a 109 lobe sep
tfs high ports, angle milled, flow 350int/295exh
jesel rocker arms
edelbrock super victor intake
aed 950cfm carb
canton oil pan
main girdle
all balanced and assembled by jay hall out of flint...
still in car can hear run
motor has been very good all year, broke 1 head gasket cause it had some off the garage wall felpro paper gaskets in it, now has cometics. also had a valve break on the big end and it punched a hole through the piston and bore that is why there is a sleeve in the motor and now has 8 brand new pistons and is .040 instead of .030....
has been 10.25 on motor with lose converter, just went 10.80@131mph with 0 passes on it, nitrous plugs, and no timing...didnt make a move until 400ft out only had a 1.8 60ft...
has been 9.000 quite a few times with a 225shot through a big shot plate,went 9.20s the other day with lots of fuel pressure, and alot of timing taken out, still fresh motor only has 5 passes on it, will go 8s with a lil more tuning...
$6500 carb to oil pan...ready to go...
pm me if interested...
here is what i know about the motor he is finding out the rest later from his engine builder
motorsport block was brand new at the beginning of the year it now has 1 sleeve in it
eagle crank
eagle rods
diamond dome pistons, .40 over 15to1comp
solid roller cam .630lift, [email protected], on a 109 lobe sep
tfs high ports, angle milled, flow 350int/295exh
jesel rocker arms
edelbrock super victor intake
aed 950cfm carb
canton oil pan
main girdle
all balanced and assembled by jay hall out of flint...
still in car can hear run
motor has been very good all year, broke 1 head gasket cause it had some off the garage wall felpro paper gaskets in it, now has cometics. also had a valve break on the big end and it punched a hole through the piston and bore that is why there is a sleeve in the motor and now has 8 brand new pistons and is .040 instead of .030....
has been 10.25 on motor with lose converter, just went 10.80@131mph with 0 passes on it, nitrous plugs, and no timing...didnt make a move until 400ft out only had a 1.8 60ft...
has been 9.000 quite a few times with a 225shot through a big shot plate,went 9.20s the other day with lots of fuel pressure, and alot of timing taken out, still fresh motor only has 5 passes on it, will go 8s with a lil more tuning...
$6500 carb to oil pan...ready to go...
pm me if interested...