Recent content by uwntsumrtII

I've got another trailer question. What have ya'll done to protect the tail of your trailer when it drags?

Anyone have a use for it? Oil burning heater, etc... I've got 11 gallons or so FREE, in Ypsi, come and get it.

Looking for ideas to keep the winch cable from dragging on the beavertail peak on my trailer. I have an 18' (4' beavertail) open car hauler with a full diamond plate floor. I was thinking along the lines of one of these... http://trailerpartsdepot.com/itemdesc.asp?ic=3143%2D4&eq=&Tp=...

Can anyone recommend a good aluminum welder in the Ann Arbor, Ypsi, Saline area? I have a small project I can bring to them.

Hey all, I have 2 tickets for sale to the OSU vs UofM game tomorrow at noon. Section 11 Row 32 Seats 3 & 4 $95 each (face value)

Hey all, Looking for some 28" slicks or dot. I would really like some Hoosier QTP's. Let me know what ya got.

What's the TGIF Run What Ya Got all about, besides the obvious title? I haven't been out at all this year. Thinkin about going tonight...

Where can I get my bottle filled near Ann Arbor/Ypsi area?

I've got a pair of Hoosier QTP's. They are worn down to the base of the ribs. How many passes you think are left in them? 12-13 second vehicle. Here's a pic... for what its worth.

I need to rent a car trailer. Towing my Dakota to an event and back. June 1st - June 5th.

brand new Summit 15gal aluminum fuel cell w/ 0-90oHm sender located in Ypsi $200

Hey all, im gonna be doing a lapping job on my heads. And im replacing the valves with new ones. Do I need to do the lap job with the old valves or the new ones?

I have a cast iron head that needs some weld/graze work done in the exhaust port. Its a pin hole on the base of the port that's seeping water. I've been recommended to Pin Point Welding. I'm also hearing the name "Chris Razor of Hi-Tech Welding". The number 734-542-9206 is all I can findall...

Ok, I looked around in the sponsor list but I've never dealt with any of them. I have a 2000 Dogs Durango R/T w/ I believe is a 46re. I need a place that I can drop the truck off at. Not looking for any extravagant modificanions. Just a full rebuild with firmer shifts. Estimates?

Is 9lbs really worth $300? K1 Technologies has a forged stroker crank that's 63lbs. Found one for $690. Scat has a lightweight one that's 52lbs. Found one for $1000.