Recent content by StanIROCZ

Block has been cleaned and new cam bearings installed. Bores show very little wear. Crank is freshly polished. I began the overhaul process but didn't follow through. Everything is currently disassembled. Cranks, rods and Pistons, block, used bearings, front, rear, and valley covers, is all...

For $550 you get: The Edelbrock base the Edelbrock throttle body Fuel rails and Holley fuel pressure regulator, and AN-6 fittings the IAC that will plug right into a TPI harness http://www.f-bodysport.com/iac.htm the other sensors (but the CTS is busted) the bracket for the MAP sensor the swivel...

Just wondering if anyone has had good or bad experience with the Hastings Auto Parts Machine Shop in Hazel Park? I have an LS1 that needs some basic work (ball hone, cam bearings, polish crank), they are close to me, and the prices seem reasonable. I work in Sterling Heights and I can...

For sale are my 'street' brakes with less than 100 miles on them: ^Delco Durastop drilled and slotted front rotors $100 ^Carbotech Bobcat pads. Tons of life on them still, like I said less than 100 miles. New price is $144. My price is $100 ^AX6 C5 Corvette REAR brake pads. A few...

For sale is an LS1 long block from a '99 WS6. Nothing is broken but it could use freshened up with new bearings etc. I checked compression and got a max of 4% difference from cylinder to cylinder. It'd be great for someone that is looking to build a motor and swap. $1000 Located in...

Anyone have a decent sheet metal brake in Royal Oak / Madison Heights Area? Shop or individual. Could even be an HVAC shop. I'd walk in with a piece of steel already cut to size with lines marked for where to bend. I just need someone to bend it for me. ~16 ga 32" long.

Anyone in the metro area have a tubing roller like the one at HF http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=99736? I'm looking to make a bowed part that is about 4' long and has roughly a 1" bow. Otherwise, any suggestions for making a bowed tube? There are rollers at...

At this point in time it’s a street and track day toy, but I’m building the car to the American Iron / American Iron Extreme ruleset http://www.americanironracing.com/ Here are some pictures from Grattan last fall: Then I pulled it completely apart to put in a cage, hard top roof...