Recent content by red2004

Brand new in the box, picked it up on trade $200 obo text me 734-341-8093 Newport,monroe,downriver http://m.lowes.com/pd/Bosch-18-Volt-1-2-in-Cordless-Variable-Speed-Brushless-Impact-Driver-with-Hard-Case/50150664 http://www.amazon.com/Bosch-IDH182-02L-Brushless-Batteries-L-Boxx-2/dp/B00HUCUHMC

Just talked to kim there....Im dropping my car off there next week for tuning and was just wondering what peoples opinions are on there service? My car 04 gt, d1sc/3.2 pulley/3 core i.c, built block, 60lb injs, cobra tank/pumps/boostapump, stock returnless system still, -8 lines under hood...

I bought a aluminum flange and the welder cant weld it to my pipe since its steel so i need a steel flange...asap, Let me know lonny 734-341-8093 Thanks.

I have a mmr 4.6 shortblock that i am just not fully knowledeable of completing the assembly process and am wondering if someone wants to help finish it to where its ready to drop in the car. Have the motor on a stand and with 1 head on but not torqued down. I will throw in cash for the...

Have a mafia that i dont need anymore part#f7373 $100 04 mustang gt gas tank just needs the bolts to secure the fuel hat and have cut the harness off for the fuel hat to put on my cobra hat, super clean $20 have a few other things also decklid with spoiler from 04 gt(torch red) mint, stock k...

Ok I was taking the car for a ride to get gas before covering the car for the winter (had maybe 1/8th tank), so let the car warm up for roughly 10min before driving, drove fine until I got to the stop sign and proceeded to get on it maybe 3/4 throttle when I left the stop sign and then the car...

Looking for some feedback.....I talked to him about building a shortblock for me......Eagle internals Thanks, Lonny

Im new to all this but I want 5-600 to the wheels, currently im on a stock block with comp270 cams,8lbs p1sc/intercooled, full bolt ons and making 400/411 whp tuned by lidio at alternative. Was looking at this kit at mmr for $1699....(Unless someone has a better option) MMR Street Mod 750SE...

Hunting season is right around the corner and was looking for a coupon to use. Thanks, Lonny

This kit is in brand new condition, there is not a spec of dirt or scratches, was only on the car for about 30 miles before I went S/C. Never seen any rain or any other mess, comes with everything that you need to install the same day. Bought this from Americanmuscle.com for I think...

I just changed my radio and am looking to change out the factory speakers and was wondering what size are people running in the doors and rear panels(convertible)? I see that crutchfeild say 5x7/6x8 for front doors and 6.5 for rear panels but i would like to do a set of components in front...

I am wanting to epoxy my garage floor and am looking for some advice/info from someone that has done this already or someone that actually does this for a full time job. I have a 2.5 car garage(attached)448 sq ft, my daily driven cars don't get parked in the garage just my mustang which never...

I have an 04 gt vert with a p1sc/8lbs,comp 270 cams,bbk upper&lower control arms,tokico blue struts/shocks,ford racing b springs,MM full length sub connects,4.10 gear,bbk Lt's,exhaust...etc.... I am looking for a set of rims/slicks as my mt et streets just arent doing it for me at the...

http://www.bossincstyle.com/bjr01.html This is my car Im just purchased this for my 04 gt and am looking for some info on the cost of this to be painted, also should i just have the hood painted off the car or take the car with it installed? Any reliable shops? Im in monroe county(newport), i...