Recent content by LITTLEMAGS

a few more pics

installed new upper and lower Merillat control arm and torque box stuff...9 inch fits good...

long way to go BUT thru floor frame ties done and installing new cage....fitting up bars and so far so good....

Sold

Out of my 04 Mach 1. Going to 9” so don’t need and would like the clear some space in garage. Stock housing with strange c clip eliminators. Strange spool and 35 spline axles. Ford racing 3.27 gear with Motorsport cover. I changed over to GT brakes due to didn’t want to grind banjo bolt to fit...

Glenn’s performance 1999-2004 mustang tank with sump. F/S Glenn’s performance sump tank. This was in my Mach 1 and has less than 2500 miles in it. Mostly track miles to be honest. Plastic canisters are mint and not all cracked up like high mile stockers. $300.00 obo -8/-10 fittings. Tank is...

reassembly starting

Hit the engine bay with SEVERAL coats clear...(lol) Have to rub a few spots (dirt nubs) from doing it in the garage BUT overall turned out fantastic. Will start putting the suspension back in. I have to ask for some advice from you guys on how to run my brake lines. I ripped them out and...

k member back from powder coating along with lower intake blasted...

sealed engine bay....since I am using spies...I have a little more time to hit is with clear. I will try to spray the clear next week. So far so good though....

after poly primed...sanded everything for high and low spots...did some more body work and then primed with K2 primer....let dry for a week and started water sanding with block and 400 grit. Will check for imperfections and fix and then prime again next week. I think the next priming "should...

PRIMED engine bay....coming along

pretty much complete kit bad ass mounting bracket. Billet aluminum... purge, bottle heater, shark nozzle, baggy of pill sizes...msd digital window switch...blow off valve...umm...some switches...etc. I am trying to CLEAN my garage... 500.00 OBO for everything....btw...bottle is 3/4 full....

More