Recent content by gdwrench

Listing for a friend.....Wayne @ Headwinds built the motor and trans 355 SBC - 12.5:1cr, Forged pistons, Eagle crank & Rods (arp), Comp Hyd-Roller cam, Dart Iron Eagle 200 heads, not sure on manifold(think it's Vic jr), has Pro Systems 750 carb on it & Moroso oil pan, MSD Distributor (85551)...

Like the title say's ...... 734-751-3132 or [email protected]

Whatcha got ?? Looking for either good takeoffs or good price on something new :coolio: Needs to happen fast 734-751-3132 ... Gary

This Nova has stock subrame so an out of the box set should even fit ....Looking for at least 2.25 primary and 3.5 collector ...pretty popular so I hope there's something laying around, pretty much need something asap. 734 751 3132 Gary

I actually have 2 drums of e98, and haven't tapped into either one. I planned on having my hotrod running much earlier this season but it's looking like early September at this point (or later) till I can even crack one open....Bummer!! The drums were 265 + 10 core per drum...a bit more than...

Just checking to see if anyone has some unused elbows laying around, maybe some straight also .....Project is underway!!

Clear out your messages killer,your cup runneth over............

Clear out your messages killer,your cup runneth over............

Already tried Darko over at P-M, no go..... Needing a Front Bumper assembly complete...Bracket's, upper pad & all. Plus I need the Headlite Mount panel, the light's and Grille are still ok, just the panel will do. If ya know who's got the shit, gimme a buz or a PM... Thanks 734 751 3132 - Gary

Here's the scoop.....I put a full exhaust on my car ( 64 Impala/Biscayne) at the end of last summer,from the Collectors (3.5) all the way back to the rear bumper is alluminized 3" tube, I used 2 Chamber Flowmasters at the rear bumper. There's a disconnect right before the Axle on either...

Carb's like new, hardly used and never raced....Has rear jet extensions "and" adaptor spacer to mount to 4150 manifold ........$500 [email protected] or 734-751-3132 Gary pics on demand

Hooker Headers, 2" Primary - 3.5 Collector, they are "heat wrapped" and in good condition...Rear tubes wrap around the framerail. Upping my CI and need too build a new set, these need too go !!.................$300 [email protected] or 734-751-3132 Gary Pics on demand

Got these back when I started my project a few months ago... I have Edelbrock Victor heads and they will not work for me, that's all I did was try too fit them, never used. They are clearenced for taller vavles and high lift cam so that's already done. They were a little over $375 new when I...

Wow, cool place.......Bunch of local guy's round' here, this should be fun !! If you race at Milan I've probably seen it run and next season is going to be a blast :thumbsups