Recent content by fzsk4p

  1. F

    Dart BB for DD/Tow rig

    Looking for a bit of advice/direction on a Dart based BBC for a DD/tow rig. First a history lesson ; Back in my working days (retired now) had the pleasure of driving several company concept trucks based on Chevy Suburbans. Ones made for foreign government evaluation/use. Several of these...
  2. F

    Anyone Re flash a GM PCM ?

    On my tow rig (2002 Silverado 2500HD with the 6.0/4L80E) I used a SuperChips handheld a few years back. While the SC worked fairly well I suspect there is a bit more power hiding in that PCM. Even with the SC set on "performance". Requiring 93 octane and no towing. I have found that pulling...
  3. F

    Ford 9 inch housing question(s)

    Converting my Jeep to a 9 inch rear axle. Both the pavement and the 4 wheel drive markets offer plenty of choices for aftermarket housings. Confused as to what might be the better way to go. Use an aftermarket Moser, Strange, SpiderTrax or Diamond housing Or A Ford housing that has been...
  4. F

    Ford 8.8 Bearing Caps/LPW Truss

    Rumor has it that the 8.8 has kinda weak main bearing caps at the carrier. Any fact to this ? Running an LPW girdle and an ARP stud kit already. Considering adding a set of Mark Williams bearing caps. Second question LPW offers the truss kit. Again any comments ? Thanks !!
  5. F

    Dana 44 Main Bearing Caps

    Looked at Mark Williams, Strange and did a Goggle. Have not come up with a source for a billet main bearing (carrier bearing) cap(s) for the Dana 44. Any ideas ?
  6. F

    Custom Battery Cables-Source

    Where is a good place to have some custom length battery cables made up ? Have a dual battery set up on my Jeeep and the cables on it are pretty cheezy. Good 2/0 cable and properly crimped and heatshrunk ends.
  7. F

    1350 billet or 1410 Yoke ?

    Thanks again for the driveshaft shops. Here is another question I am trying to figure out. With my Jeep I am converting to High Pinion Dana 60`s F/R. Drive line angles will be fairly flat. So something like a Mark Williams billet 1350 yoke or a standard Spicer 1410 ? In any case the yoke...
  8. F

    Custom Driveshafts Who Does Them ?

    Looking for an area shop to make up a couple of custom shafts for my 4 wheeler. 1 ton CV`s 1410 yokes that kind of thing. Thanks !!
  9. F

    AKDM

    Anyone deal with them ?
  10. F

    Prepping a Dana 60

    Hey folks, 1st timer here. While out in Pomona for the Finals had the chance to walk through the vendors. Strange, Mark Williams, Moser all had there displays out. Nice stuff. You pavement guys have a lot of aftermarket support. Us 4 wheel drive folks don`t have the same stuff. Like to ask...
Back
Top