Recent content by Beigg

Having a few domestic vehicles equipped with tire pressure monitoring sensors; I am looking to pick up a TPMS reprogramming, training module, resetting, & activation diagnostic tool. Those handheld "relearning" tools will not do, as I already have tried those without success. The GM & some...

Dont forget the furious Ford Escort Pony

Does anyone have a company they'd recommend that is a local freight/shipper with on vehicle forklift capability that will do a residential delivery? Looking at a lift that comes on one pallet and weighs approximately 1,900 lbs to be picked up at a shipping terminal then delivered to a...

Looking at overhauling a g80 and it has two pins that need pressing out. j-26252 is the tool gm uses, but the cost of that tool exceeds the one time use I'd have for it. I thought about notching a c clamp, but if i could find the j tool for less than 50, id rather go that route. Anyone have...

Delete No longer needed.

Doing the balance shaft chain assembly for a 1st gen 2.9L Colorado & am in search of a driver side balance shaft end with the center bolt. A part number for the end piece would be good, I do not need the entire balance shaft. I'm uncertain if the 3500s & 3700s are the same. it goes to the...

The work truck is in need of a new windshield & the expense will be being paid out of pocket. Any east side [south east macomb] places for an inexpensive recommendation?

Delete No Longer Available.

If you have or know someone that has flat stock metal they're looking to get rid of, pm me. Rather put some funds in a MM pocket than order new. All I'm doing is practicing making random stuff or learning how to better myself at welding. Looking for the following as of current: Aluminum...

Anyone use michigan first credit union? Good, bad, meh? I see them in most Krogers & spread across S.E. Michigan. Looking for a bank or C.U. that doesn't charge if a direct deposit is not recurring & doesn't charge a fee for a minimum account balance. The account would always retain 500...

The truck in question is a 1994 F150 with a 351W [GT40 Heads, long tube headers] & a AODE 4x4. What are the options to tuning this setup? Is the ECM able to be calibrated or would a harness swap using another Ford ECM be optimum? If a swap with ECM is the best solution, which one would be...

Has anyone had experience with HPT for deleting the Intake Manifold Runner Control Valve in the Dodge Caliber SRT-4 pcm? looking into fabricating an intake manifold for the 2008 Caliber SRT-4, but am not sure how to go about it using HP Tuners. If it has been done, where in the software of HP...

Figured I'd offer up a job to a MM or maybe a MM can refer a good reputable poc. In a month if not sooner, I'd like to have a privacy fence installed & who ever is going to be doing the work will need to pick up the materials, have the necessary tooling, needed manpower, & of course have the...

Can anyone verify if part number: 04884805AD is the same as these part numbers? 4884805AF, 68011570AA, 68011570AB, 04884805AF, 68011570AC, 04884805AC Thank you in advance!

delete delete